CAD Forum

Happened on submission, but went away when I retried.

[sarc] It's probably because of your use of the word "symmetry". Everyone should be modelling everything in place, regardless of symmetry.[/sarc]

HerrTick wrote: ↑Sat Mar 27, 2021 11:03 am Happened on submission, but went away when I retried.

Blacklisted.png

Yeah, we do subscribe to a blacklist. You may have pissed someone off. I know who you are, though, and we've got your picture right there in your avatar, so you can't escape. I'll take care of this when I get back on the admin box. Sorry for the inconvenience. Nice to know that someone is actually reading your stuff, though, isnt it?

There's a subscription? That's creepy.

SW forum was moderating 100% of my posts last week. I think they were mad about the Parler remark.

Ok, that shouldn't happen again. I tried some overlapping settings, let's hope this doesn't just invite the wrong sort of folks.

matt wrote: ↑Sat Mar 27, 2021 5:54 pm Ok, that shouldn't happen again. I tried some overlapping settings, let's hope this doesn't just invite the wrong sort of folks.

I think it's way too late to be worrying about that.

Glenn Schroeder wrote: ↑Sat Mar 27, 2021 9:45 pm I think it's way too late to be worrying about that.

No kidding, Matt let the wrong ones in the moment he created this site.

Double-moderated on SW forum