how to unfold this section?

[chz036]

Hi guys
how to unfold this section Sheet metal part?

steel.rar

(102.51 KiB) Downloaded 36 times

[KennyG]

Use the Blank Body command to flatten it.

[chz036]

Use the Blank Body command to flatten it.

could you show me with a picture? i still can not do that, thanks!

[chz036]

the twist section seems not to be faltten in solidedge.

[KennyG]

[chz036]

That's great and i also made it, thanks!

[Jaylin Hochstetler]

SW geeks, how would you do this in SW? How would you flatten a bend like that in SW. I don't think it's possible in SW...

[Dennis Bacon]

Good question @Jaylin Hochstetler ,,, I'm impressed with the Solid Edge sheet metal capabilities. Going to have to get a trial version and immerse myself into it. In SW I would make two 3d sketches and do a lofted bend.

I don't think either SE or SW gives you quite what you would expect, but probably the overall length is fairly close. If this part was accomplished with a twisted rectangular blank it probably would look more like this.