CAD Forum

Hi,

I am updating a old SW drawing, I went in a replaced the sheet properties with the company's latest and greatest.
Now here is where I can't figure out is how to add a revision anchor, the sheet had Template instead of Sheet format and when I right click there is no anchor options:
Now on the bill of materials if I right click, I get a anchor option:
On the revision table I again don't have the option:
I know this should be simple but how do I add the latest and greatest to this drawing short of replacing it?

Regards,
Jim

Right click in the drawing sheet, select 'Edit Sheet Format'.
Right click a point in the sheet format and the 'Set as anchor' item should be on the pop-up menu. From there you can specify which type of table should be anchored there.

Hi again,

I tired it and as you can see no anchor option:

I would have thought this would be an easy one to fix or that the anchors would have imported with the new sheet properties.

Regards,
Jim

Hi,

Guess my eyes are going quicker than I thought, joys of old age.

Regards,
Jim

You need a drink.