Page 1 of 1
save a sheet metal part as a .dwg there is a prefix "flat pattern" that shows up all the time
Posted: Fri Oct 20, 2023 3:29 am
by velko.nestorovski
When I save a sheet metal part as a .dwg there is a prefix "flat pattern" that shows up all the time? Is there a way to remove this? Just time consuming to remove every time.
Re: save a sheet metal part as a .dwg there is a prefix "flat pattern" that shows up all the time
Posted: Fri Oct 20, 2023 4:25 pm
by jcapriotti
OOTB no. You might try a macro.....then you could have it name the file whatever you want.
This may be overkill:
viewtopic.php?p=14464&hilit=dxf+dwg#p14464
Re: save a sheet metal part as a .dwg there is a prefix "flat pattern" that shows up all the time
Posted: Mon Oct 23, 2023 2:08 pm
by TTevolve
Create a drawing with the flat pattern view and save that as your DWG file. You can delete all the title block so your DWG file will only have the flat view and bend lines/notes