Page 1 of 1
Zebra Stripes
Posted: Fri Aug 06, 2021 6:53 pm
by Maha Nadarasa
How to improve this Zebra Stripes? This is G1 relation between curve and surface. I tried with G2 and G3 relation but it did not work.
Re: Zebra Stripes
Posted: Fri Aug 06, 2021 7:52 pm
by Lucas
When you work with surfaces keep in mind to select edges so you can apply tangency in the connections - Loft, Boundary and Fill, If I am not mistaken.
So in this case the easiest way is the Boundary Surface:
Re: Zebra Stripes
Posted: Fri Aug 06, 2021 8:09 pm
by Lucas
Also changing the arc to spline:
Re: Zebra Stripes
Posted: Sat Aug 07, 2021 3:22 am
by Lucas
And increasing the degree of the spline you can start the spline curvature close to zero, making Curvature to Face possible. This is as far as I know for now .-.
Re: Zebra Stripes
Posted: Sat Aug 07, 2021 11:30 am
by Maha Nadarasa
@Lucas
Thanks for the help.