Coincident but not merged points...?

Use this space to ask how to do whatever you're trying to use SolidWorks to do.
Post Reply
Ballfreak10
Posts: 39
Joined: Wed Mar 17, 2021 11:05 am
Answers: 0
x 26
x 3

Coincident but not merged points...?

Unread post by Ballfreak10 »

Hi all,

The attached screenshot is the error message that I got when I tried to use a sketch to make an extruded cut offset from a curved surface. Could it be because the selected surface is curved? Also attached the file to the post.

Any help/insight is appreciated :).

Thanks in advance,


image.png
Attachments
Leg.SLDPRT
(106.71 KiB) Downloaded 58 times
by SPerman » Fri Apr 23, 2021 4:05 pm
You've asked the same basic question in 3 or 4 separate posts. You need to do enough tutorials to understand a closed sketch.
image.png
Go to full post
Top
User avatar
SPerman
Posts: 1874
Joined: Wed Mar 17, 2021 4:24 pm
Answers: 13
x 2052
x 1709
Contact:
Contact SPerman

Re: Coincident but not merged points...?

Unread post by SPerman »

You've asked the same basic question in 3 or 4 separate posts. You need to do enough tutorials to understand a closed sketch.
image.png
-
I may not have gone where I intended to go, but I think I have ended up where I needed to be. -Douglas Adams
Top
Post Reply

Return to “How To Questions”